Posts Tagged ‘quarter turn taps’

Maintenance Hints and tips

Stop cocks

Care and maintenance required for these small pieces of plumbing is an absolute must. It takes very little effort to spray once a year with lubricant and turn it off and back on again. That’s all! Apart from one other small tip, and that is to turn the stop cock on fully, then back by half a turn. This means that if you don’t maintain the stop cock on a regular basis, the metal shouldn’t seize up.

The stop cock is really just a tap, imagine if after brushing your teeth in your bathroom basin, that you couldn’t turn it off again? The only thing left is the stop cock in your drive, or out on the street. Believe me, you do not want to be involved with trying to turn this off at the bottom of a 2 foot deep hole 4 inches square.

 Gate valves

As an installation company we find that over 90% of bathrooms we replace require us to change this low pressure valve as soon as we arrive. If you have a hot water cylinder, you will find one of these valves in your airing cupboard. It controls the flow of cold water down from the tank in the loft to the bottom of the hot water cylinder. In a crisis this can stop the flow of hot water to the taps in the house. Unfortunately this valve is rarely maintained and can be less than useless.

 Tap Washers

When these fail it makes the dripping tap a nightmare, along comes the limescale again. The only way to deal with this problem is to get the tap apart and replace the washer. We try to keep as many alternatives in stock as possible. We also keep tap repair kits which contain a cartridge, the insides, to many modern taps, they also contain new tap heads as well.

Modern CD, or quarter turn taps do not have washers. These are more difficult to deal with because they are designed to fit in the tap and are different shapes and sizes, so generally you need to know which make of tap it is and in some cases even which model. Again, we keep spares, so give us a try, you never know!

 Hot Water cylinders

These vital tanks of hot water for showers or baths give little trouble, even on a yearly basis, but it is still worth giving them a visual once over regularly. Trouble spots are usually the junctions where pipes are joined. If they are weeping you will see a white coating around the joint. Guess what, good old limescale again! Don’t try to remove this, ask a professional to have a look; you don’t want the joint to fail and leak with a full tank of hot water.

 Toilets

Most households have had trouble with their toilet flushing, or filling valves.

The filling valve could be compared to a tap that turns itself on and off. I turns on when the float inside goes down with the water level when flushing. It turns off when the water level rises again, this action forces a lever against a rubber diaphragm. This diaphragm can split with age and needs replacing. Again, there are many different variations, so take the old one with you when looking for a replacement. Also note which way round it was in place, they don’t work when reversed.

The flushing valve can be of two types, the first is one that is worked by a lever, this is the original siphon type, and the second is the modern push button type. These two systems are totally different and stop working for different reasons. Like the older siphon type, there are different makes of modern ‘drop’ valves and push button mechanisms. If you can find a makers name it really does help. We can also try to help with identification if we can see a picture taken on your mobile phone perhaps.

We can usually track down most makes and types of toilet cistern internal fittings, but it can take a while sometimes.

We hope you find these hints and comments helpful. If you have any specific ones, why not try contacting us, we might have an immediate answer, but if we don’t we will always offer alternative solutions.